Determination of the pile capacity is always a major concern for the safe geotechnical engineering design. Different direct and indirect methods have been proposed for determining pile bearing capacity such as static and dynamic approaches. Each method depends on the condition of the soil and type of pile as well as accessibility to necessary information. In this study bearing capacity of drive...

An open ended pipe pile can become plugged when sufficient frictional resistance is developed by the inner soil cylinder within the pile (soil plug), thereby preventing further intrusion of the soil into the pile. When plugging occurs in an impact driven pipe pile, a complex interaction between the pile and soil plug takes place, causing the propagating stress wave to undergo an abrupt change. ...

Received: June 12, 2017 Revised: October 24, 2017 Accepted: November 03, 2017 Abstract: Background and Objective: Prestressed high strength concrete pipe pile (PHC) shows brittle fracture when subjected to more than its own bearing capacity. Therefore, the non-prestressed steel bar is added to the PHC pipe pile, that is, the mixed reinforced pipe pile (PRC). The mechanical behavior of PRC group...

In order to study pressed pile test and ultimate bearing capacity character of large-diameter steel pipe pile, based on two high-piled wharfs of Zhanjiang Port, pressed pile test and numerical simulation of three large-diameter steel pipe piles are analyzed in this paper. Anchored pile method is used to pressed pile test, and the curves of Q-s and ultimate bearing capacity are attained. Then th...

The wind turbine foundation serves as a permanent construction in the harsh marine corrosive environment, its anticorrosion design is essential to the safe use of the wind turbine structure. At present, there is a significant controversy over the local corrosion mechanism (such as pitting corrosion, and crevice corrosion) and its diffusion mechanism in the academic circle. In the paper, the Far...

Simulation analyses for in-situ cyclic loading tests in cohesive soil were conducted to indicate that finite element models considering nonlinearity of material , pile-soil separation and a loosened layer valid evaluating lateral resistance steel pipe piles with wings driven by rotational penetration. The results analytical studies demonstrated pile head load approached without when displacemen...

Abstract: According to the Winkler assumption, the form of the pile constraint could be simplified as bottom fixing and top free. Considering the influence from resistance of soil around pile, the equations on calculated length for buckling stability of steel pipe pile when the portions along the pile length were constrained in the uniform foundation and the layered foundation were respectively...

This paper mainly uses the method of model test to study ultimate uplift bearing characteristics a single pile with different length-to-diameter ratios, from distribution laws capacity pile, axial force and side friction perform analysis. The is made PVC pipe, resistance strain gauges are attached both sides pipe. value pipe under load conditions measured obtain working behavior during process ...

This paper presents 53 well-documented cases of the short-term set-up of open-ended steel pipe piles driven at two fields in the North Sea. Increases in soil resistance during driving (set-up) were observed when pile driving was re-started after delays typically ranging between 24 h and 100 h. The soil encountered at the sites consisted of overconsolidated sands and clays, where the clays varie...